Restring Weed Wacker

Everyone hates weeds.

Weeds are considered equally pests past most homeowners. Luckily, we have some powertools on our side to help us in our battle.  Weed eaters (aka the cord trimmer or weed wacker) are the perfect tool to help united states win against weeds.

But weed eaters do require maintence.  1 of the most common, and easiest, repairs y'all tin can practise at home is to put new cord on the trimmer head.  This article will explain how to put line on a weed eater.

Tools Needed:

  • Screwdriver
  • Knife or strong scissors
  • Replacement string line.

Stride-Past-Step Instructions on How To Put String In A Weed Wacker

Step 1: Starting time, you take to buy a trimmer line. This product is usually bought in rolls. You lot tin can purchase this product from a hardware store or an online retail shop.

There are different sizes – thicker string is meliorate for bigger weeds and more powerful engines.  Too small a line for your job and you'll struggle to cut the weeds.  Likewise big a line, and you'll have functioning issues with your trimmer.

Refer to your weed eater manual to observe the right line size.   Some pop dimensions are 0.065 inches and 0.095 inches.

Step two: In one case yous have purchased the trimmer line, then, you are prepare to do your work.  One easy way to mensurate the right amount of line is to pull off arm lengths.  Take hold of the line in one hand, and with the other arm concur the new spool against your shoulder.  With your first manus, grab the line at the spool, and pull outwards.  Trimmer line measuring about 12 to 15 anxiety can be held by nearly weed eaters.  This will be 4 or 5 arm lengths depending on your size.

Stride three: The string is at present ready to be loaded to the trimmer.  Remove the head on the spool on your weed eater. Sometimes it removes by pushing in tabs – sometimes it requires removing a screw.

Stride 4: Observe which manner you need to load the string.  The head will spin in 1 direction, and the cord needs to be loaded accordingly.  There volition be an indication on the back of the spool.  Anchor the string in the spool head, and wind in the correct direction.

Footstep 5: There are dissimilar types of cord trimmer heads.  If you lot have a double, the trimmer head will take two holes on opposite sides. When connecting the spool, yous should be inserting one end of the string through one pigsty and the other end goes through the other hole. Y'all should and then slide the spool into the trimmer caput and turn it to the management where y'all volition be able to wound it up tightly.  We have a guide on how to string a weed eater with two holes here.

If you accept a single, it will be easier.  You just need to run the string through the only hole in the caput.  Either way, place the head securely back in the trimmer.

Step six: Push the crash-land head of the spool down and try to pull string out of the trimmer head.   If you can remove line from the spool –   you are set up to get.   When you eventually need to get more line every bit you are out trimming weeds, simply puch in the bump head to pull more line.

Step 7: If you lot have besides much line, you can cut off the excess.  While yous are looking at your trimmer, make clean it of any debris.

I promise this guide to calculation new cord to your trimmer is helpful.  If y'all have any other advice, please leave it in the comments below!